Din 2353 standard pdf

Rating: 4.8 / 5 (2023 votes)
Downloads: 44856

CLICK HERE TO DOWNLOAD









The tube fittings and components listed in this 1 Scope. depends on the material of a connector and sealcarbon steel: from °C up to +°C This standard specifies the design and dimensions of compression fittings and couplings, with stud ends in compliance with DIN, DIN or DIN, as well as IS, ISand IS, which are made from standardized components and are not covered in ISSee clausefor list of coupling assembly TUBE FITTING (DIN,JIS) Seamless precision stainless steel •Stainless steel tubes (e.g.), code X6CrNiMoTi, must be cold-drawn and seamless, heat-treated without formation of scales, type m to DIN, provide tolerance to DIN, PartThe following tube wall thickness are suitable for use: Calculation HSME Corporation The corrosion resistance of Guardian Seal™ cover exceeds the German VDMA K5 standard (minhours in a salt spray chamber until red corrosion appears), qualifying the connectors for operation in the most DIN pipe fittings are supplied in two material versionscarbon steel (zinc-plated or phosphate-coated) standard seal: NBR rubber,stainless steel (AISI) standard seal: Viton. Working temperature Allowable working temp. DIN Part+specifies the dimensions of stud ends and tapped holes for metric fine pitch thread and pipe thread applicable to compression Westfair West Drive Houston, TX, USA Toll-Free Fax Available in three sizes, the bite type fittings and accessories are manufactured in accordance with DIN Standards. The corrosion resistance of Guardian Seal™ cover exceeds the German VDMA K5 standard (minhours in a salt spray chamber until red corrosion appears), DIN pipe fittings are supplied in two material versionscarbon steel (zinc-plated or phosphate-coated) standard seal: NBR rubber,stainless steel (AISI) standard DIN Tube Fittings.